Real parts. Real tolerances.

A sample of parts machined to customer specification, illustrating typical size range, materials, and the burr-free, concentricity, hole-positioning, and tight-tolerance requirements common across our valve, coupling, subsea, and flow-control programmes.

SPEQS machined valve and coupling component, approximately 2.5 inch diameter by 2 inch, stainless steel
Approximate Size
Ø2.5″ × 2″
Material
Stainless steel to BS970 Pt.1 Gr. 316S11
Application
Valve & Coupling
Special Note
No burrs or sharp edges including intersecting holes and drill breaks
SPEQS machined valve and coupling component, 3.4 by 2.8 by 2 inch, stainless steel
Approximate Size
3.4″ (L) × 2.8″ (W) × 2″ (H)
Material
Stainless steel to BS970 Pt.1 Gr. 316S11
Application
Valve & Coupling
Special Note
No burrs or sharp edges including intersecting holes and drill breaks; bore machined through the back end of 22.00/22.033 to be 100% concentric to the front bore
SPEQS machined deep sea exploration component, 3.5 inch diameter by 14 inch, 17-4PH stainless steel
Approximate Size
Ø3.5″ × 14″
Material
17-4PH stainless steel
Application
Deep Sea Exploration
Special Note
Critical hole positioning requirement, per reference points marked on part
SPEQS machined deep sea exploration component, 3.7 inch diameter by 14 inch, 17-4PH stainless steel
Approximate Size
Ø3.7″ × 14″
Material
17-4PH stainless steel
Application
Deep Sea Exploration
Special Note
Critical hole positioning requirement, per reference points marked on part
SPEQS flow control component as received from customer for maintenance SPEQS machined flow control component, 7 inch diameter by 12 inch, stainless steel
Approximate Size
Ø7″ × 12″
Material
Stainless steel
Application
Flow Control
Special Note
Perpendicularity 30 micron, flatness 30 micron, positioning 50 micron. Machined by SPEQS and sent back to the customer following maintenance, refurbishment and repair work, not only new-build parts.
Collage of additional SPEQS machined components in differing configurations

Other samples of differing machining configurations.